EEPROM 95160 PDF

STMicroelectronics MW Series EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for STMicroelectronics . Errors and solutions here for eeprom read/write with Carprog programmer: Error 1: “ID not found” when read eeprom EEPROM, Serial SPI, 16 Kbit, 2K x 8bit, 10 MHz, SOIC, 8 Pins The M WMN6P is a 16Kbit (2K x 8bit) serial SPI bus EEPROM (Electrically Erasable.

Author: Shakak Kagajora
Country: Maldives
Language: English (Spanish)
Genre: Life
Published (Last): 24 June 2007
Pages: 496
PDF File Size: 1.10 Mb
ePub File Size: 17.70 Mb
ISBN: 333-7-93540-817-7
Downloads: 49709
Price: Free* [*Free Regsitration Required]
Uploader: Meztigis

Hi, it seems i’m doing something right then! Reply 3 ZLM Posts.

MCUmall EPROM BIOS Chip Burner Forum – 8pin

It is SOIC8 mil chip. What is your eeeprom adapter part number? Reply 13 benaknoun Spain Posts. Try to power up the board and do not connect pin 8 Vcc pin.

Reply 19 ZLM Posts.

I think it should seprom SOIC8 mil chip. If it is “”, then it has no ID on this chip. Reply 8 benaknoun Spain Posts. That is safe and fastest way. Reply 16 benaknoun Spain Posts.

  DESIGN OF VUILLEUMIER CRYOCOOLER PDF

Carprog reads/writes eeprom with A4/A6 adapter | OBDIIcom Official Blog

Chip is blank does this mean this chip is empty??? Hi, ok forget this chip, eepgom damaged Reply 4 benaknoun Spain Posts. Reply 15 ZLM Posts. Reply 6 benaknoun Spain Posts.

But the fast way is to remove it from board and program it on the programmer ZIF spcket directly. Reply 9 ZLM Posts.

Reply 2 benaknoun Spain Posts. All other pins are pin to pin connect to programmer socket. It should be able to open it by same software. Hi, i have connected the tool to the chip and adapter to the programmer.

Also, when i click on ID, it says “function not supported on this device” Image Eprom What is your chip on board? The wire can be any wires, as long as you can solder it. Reply 12 ZLM Posts. Reply 18 benaknoun Spain Posts.

Carprog 9.31 reads/writes eeprom 95160 with A4/A6 adapter

Most of used on-board chips should have something. The “Device blank check failed ” means the chip is not a blank chip, there are some data in the chip.

  EFMB STUDY GUIDE PDF

Reply 7 ZLM Posts. Reply 1 ZLM Posts. What is exact part number?

I believe they will do the job. Which part number you selected in software? Device blank check failed at address: Also, another question please about the same chip: Hi, thanks for your reply, here eeprom the numbers on the chip: